Release

Search

Calls between SIP phones (on-net calls)

Link copied to clipboard

Checklist

Link copied to clipboard

Use this checklist to check off the operations you have completed while performing the system setup according to the instructions in this chapter. Please be sure to perform all of the operations in the order designated (all of the boxes should be checked), otherwise, the service will not work.

The checklist below assumes that you have already configured the basic SIP service according to the instructions provided in the earlier chapters.

Operation

Done

Rating configuration (Customer)

Enter rates in tariff B (which applies to your customers’ outgoing calls) for the special destinations describing phone-to-phone calls, i.e., the rates you plan to charge your customers for on-net calls

Enter rates you plan to charge your customers for incoming on-net calls in tariff C (which applies to your customers’ incoming calls)

Modify a customer tariff for outgoing calls

Link copied to clipboard

Add the rates you plan to charge your customers to the tariff for on-net outgoing SIP calls.

  1. On the navigation menu on the left, select Service catalog and click Tariffs.
  2. On the customer tariff’s panel for outgoing SIP calls, click Rates.
  3. On the Add rate panel, fill in the rate details:
    • Destination – in this case there are two destination prefixes that you will use. VOICEONNETRX refers to all calls made to the same customer’s IP phones (calls within a single PBX environment). VOICEONNET specifies calls made to any IP phone within a current virtual PortaBilling environment.
    • The rest of the parameters are identical to those used when setting up the basic SIP service.

      Add the rates

  4. Click Save. Rates for on-net outgoing calls

Modify a customer tariff for incoming calls

Link copied to clipboard

Add the rates you plan to charge your customers to the tariff for on-net incoming SIP calls.

  1. On the navigation menu on the left, select Service catalog and click Tariffs.
  2. On the customer tariff’s panel for incoming SIP calls, click Rates.

    Add a rate

  3. On the Add rate panel, fill in the rate details:
    • Destination – in this case there are three destination prefixes that you will use. INCOMINGNRX refers to all calls made to the same customer’s IP phones (calls within a single PBX environment). INCOMINGN specifies calls made to an IP phone within a current virtual PortaBilling environment. INCOMING refers to all incoming calls from any destination – whether it comes from another IP phone or a cell phone/landline outside of the network.
    • The rest of the parameters are identical to those used when setting up the basic SIP service.
  4. Click Save. Rates for on-net incoming calls

On this page

Release
What's new
Admin manuals
Handbooks
API
UI help
Back to main menu
Search