Step 08: Network & host name

Link copied to clipboard

Step 8_Network_host name_1
  1. On the Installation summary page, choose Network ” host name.
  2. Specify a fully qualified host name for the current server.
    The host name should not contain dashes.
  3. Choose the network interface that is connected to a private LAN segment and click the Configure button.
  4. Go to the IPv4 Settings tab.Step 8_Network_host name_2
  5. From the Method menu, choose Manual.
  6. In the Addresses section, click the Add button and specify the following network details:
    • Private IP address that will be used for internal communications between servers Network mask
    • Default gateway
    • Specify DNS servers.
  7. Use commas to separate multiple DNS server addresses.
  8. Select the Require IPv4 addressing for this connection to complete checkbox.
  9. Go to the General tab.Step 8_Network_host name_3
  10. Select the Automatically connect to this network when available checkbox.
  11. Click Save.Step 8_Network_host name_4
  12. Make sure that this network is enabled and that the corresponding switch button is set to “ON.”
  13. If the server also requires a public IP address, choose the network interface that is connected to a public LAN segment and repeat steps 4–11 (specifying network details that will be used for external communication for steps 5–6).
  14. Click Done.
    Make sure that the Automatically connect to this network when available checkbox is selected for both networks.

On this page