General configuration (Connection)

On the General configuration panel you can change a gateway parameters and connection capacity, define a service policy and/or the vendor authorization. Note that some fields are read-only. This depends on the service and connection type. To save the changes, click Save.

This shows whether the system identifies a remote gateway by its IP address or its gateway ID or by both.

This shows the IP address of the remote gateway.

This shows the port to connect to on the remote end.

This shows the name for the remote gateway. This is used when it is not possible to determine the identity of the remote party (and thus the connection/vendor that the call goes to) by its IP address alone. This ID is used to identify the connection based on additional information available in the accounting record.

This shows the node used to transport traffic for this connection.

This shows a name of a previously assigned service policy. This is a predefined set of options which are applied to traffic going through this connection.

Note that the selected service policy may be overridden by the one defined for the account of the calling or called party (depends on the connection type).

This shows the maximum number of simultaneous sessions the connection can support.